If you are seeing this you are not logged in to Bowl-Tech. Remove this notice by Registering or Logging in
By your continued use of this site you agree to the following.
You are over the age of 18 and have had supervised training in safety and operations of the equipment you work on.
Bowl-Tech does not warrant or guarantee the accuracy of information found on this site. Bowl-Tech, its officers, site Admins or Moderators will not be responsible in the case of losses financial or otherwise as a result of use of ANY information on this site.
Bowl-Tech is not a substitute for proper training on bowling equipment maintenance. You will seek personal training from trained professionals within your center with regards to safety & maintenance practices while working on bowling equipment.
Posts on the site are made by registered members and each member is responsible for the content and accuracy of their posts.
If you can not agree to any of these terms of use above or are not at least 18 years of age you are asked NOT to visit Bowl-Tech or utilize its content. To visit the Bowl-Tech Terms of Service and Rules CLICK HERE
Please join our community. It is easy and gives you additional access to forums and other tools. CLICK HERE to join
Announcement
Collapse
No announcement yet.
Need Help / looking for some parts for are new used masking units
Need Help / looking for some parts for are new used masking units
ok this is what im looking for ~
1) wire harness Part# 23600178 the male plug that goes in to masking unit board Part# 236-001-810
795
the male plug is white
and if anyone has the green rectangle plug that goes in to the chassis
i hope somone can help us out
we have called AMF and our Dis and they are no help all is on BACK ordered we would like to get the masking units installed by 2032 ~LMAO~
Re: Need Help / looking for some parts for are new used masking units
Which model masks do you have? That would be helpful to know in assisting you. I have AMF spectrum masks, and the plug the goes into the board is white. Maybe I have the same masks you do. I had better luck getting parts from a local electronics store than I did from AMF.
Give me a hammer and some duct tape and I can fix it!
Can somebody give an explaniton how pins 2, 3, 6 are supposed to be connected. I had a shortcircuit there for the drive motor connection because of water leakage.
I have a distributor that is pulling the belt hard to the left in the nine pin position (and possibly 6 pin), but seems fine in the other spots. As you can see the residue and...
I have several Pin Elevators that I believe to be out of round on my XLi's and was curious if anyone has ever run across this before and is so, what you did about it.
I'm...
Working...
X
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment