Announcement

Collapse
No announcement yet.

Spectrum Masking units

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Spectrum Masking units

    Hey guys,
    I have spectrum masks and want to upgrade the panels. Do the C-90 panels fit in the spectrum frames? I'm getting kinda tired of looking at the same 4 designs all the time and they are from 1987 and look a little outdated.
    Give me a hammer and some duct tape and I can fix it!

  • #2
    Re: Spectrum Masking units

    There are typically two heights of graphic panels:
    36" & 42"
    Measure which you have and you should be able to get them from most anybody.
    I don't know - I've never seen Spectrum masks.

    Comment


    • #3
      Re: Spectrum Masking units

      Off topic, I apologize.

      Chad...

      Be sure to check your private message box for a reply.

      Again, I apologize for the Off topic.
      "Where are we going, and why are we in a hand basket?"

      --Kat

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse
      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
       

      Approach Wear - DBA IQ/Anvilane

      Our approach panels have a lot of wear at the joint between the first approach panel and the approach/heads panel. Nearly every one has the printed image worn through to various...
       

      Rake sweeping out of time, and pin launching onto lane.

      I work on some nice old Brunswick A-2 pin setters. Most issues I've come across haven't been to problematic to figure out. But being I can't seem to get it to recreate the issue...
       

      Strange sweep problem

      I’m a rookie mechanic and have been working on pinsetters for 2 years. One of my lanes has a problem with a sweep possibly coasting. I don’t know what could be causing it...
       

      GSX Distributor shaft bearings

      Two part topic:
      1. Plastic bearing (#66) used in place of regular sealed bearing (#51) -- thoughts?

      2. ANY of these bearings with the black support mount...
       

      The Legacy of the A2

      I was recently disheartened to learn that a bowling center that I once serviced was actively looking to replace their A2's. I understand that most military bases and educational...
       

      Table turning on short stroke.

      Hello dear Bowltech members.
      First let me say thank you for your time. am plagued by a big issue for three weeks now.
      our technician is working full time on another...
      Working...
      X