No announcement yet.

Elco Plug


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Elco Plug

    We have been told that the flat green elco plug (female side going to the 82-70 machine-not the male connection in the 82-70ss chassis)is no longer available. Does anyone know if that is true?

    If, in fact, it is no longer available, do any of you all know where one may be obtained?

    If they are obsolete and no longer available, what are you all doing when one breaks?

    Thanks in advance!!!!!!

  • #2
    Re: Elco Plug

    I doubt this as there are several masking unit manufacturers that supply the cable for the Elco chassis. The last job I did was Horizen and it had new elco connectors. I was also able to find the pin extractor, but I don't remember where.
    You can probably call any mask manufacturer and get a plug.
    This post is not an unpaid promotion of my business.


    • #3
      Re: Elco Plug

      Stahl's Seventy's; Elco Mask Connector,part#000 025 886. Mask Connector pin 000 025 886-S & Terminal Removal Tool #000 025 886-SRT.
      If at first you don't succeed, try, try, again. Then quit. There's no use being a damn fool about it." -W.C.Fields


      Topic Starter RibbonScript


      Adsense Classic 2

      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.


      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...