Tweet
OK Here is a stupid question I can't get a nut off of the shaft on my Westinghouse gearbox. OK stop laughing now and read on....... [img]/content/btubb/images/%%GRAEMLIN_URL%%/laugh.gif[/img] [img]/content/btubb/images/%%GRAEMLIN_URL%%/laugh.gif[/img]
On a gearbox that we have a bearing on the shaft that runs from the stator into the gearbox that needs to be replaaced. We have the new bearings. I took everything apart fine except can't seem to get the nut off of the bottom of the shaft. Any ideas? Where I am so far is I cut a 3/4" endwrench but I cannot get enough leverage to break the nut loose.
Thanks guys for all the help over the past few seasons.
On a gearbox that we have a bearing on the shaft that runs from the stator into the gearbox that needs to be replaaced. We have the new bearings. I took everything apart fine except can't seem to get the nut off of the bottom of the shaft. Any ideas? Where I am so far is I cut a 3/4" endwrench but I cannot get enough leverage to break the nut loose.
Thanks guys for all the help over the past few seasons.
Comment