Announcement

Collapse
No announcement yet.

cushion mod

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cushion mod

    Here's a mod to the rubber cushion piece on the BDS (note that mod wasn't done on the same lane).

    Before


    After


    There's a groove cut about 2" deep in the rubber to keep it there...this was something I learned in pinspotter school. I think it's pretty cool so I figured I would share.

  • #2
    Re: cushion mod

    I cut a notch in the sponge pad for the protection pad to fit into... Same principle: Keep it where it’s supposed to be.

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse
    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
     

    Approach Wear - DBA IQ/Anvilane

    Our approach panels have a lot of wear at the joint between the first approach panel and the approach/heads panel. Nearly every one has the printed image worn through to various...
     

    Rake sweeping out of time, and pin launching onto lane.

    I work on some nice old Brunswick A-2 pin setters. Most issues I've come across haven't been to problematic to figure out. But being I can't seem to get it to recreate the issue...
     

    Strange sweep problem

    I’m a rookie mechanic and have been working on pinsetters for 2 years. One of my lanes has a problem with a sweep possibly coasting. I don’t know what could be causing it...
     

    GSX Distributor shaft bearings

    Two part topic:
    1. Plastic bearing (#66) used in place of regular sealed bearing (#51) -- thoughts?

    2. ANY of these bearings with the black support mount...
     

    The Legacy of the A2

    I was recently disheartened to learn that a bowling center that I once serviced was actively looking to replace their A2's. I understand that most military bases and educational...
     

    Table turning on short stroke.

    Hello dear Bowltech members.
    First let me say thank you for your time. am plagued by a big issue for three weeks now.
    our technician is working full time on another...
    Working...
    X