Announcement

Collapse
No announcement yet.

5 Pin holder flaps

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • loadtoad
    replied
    If you were going to replace the harness, go ahead and follow through. Chaffing in the older harness could certainly be the issue, but can be fixed with proper wire handling repair work -- which will give you a spare harness for other issues in the future. So yeah, just complete the swap.

    Leave a comment:


  • walledup
    replied
    Well I tried looking and trying following.. Switched holders to a known good holder same result. Switching I.O board from next lane and same result . So now i am taking out the deck harness which I did and ordered a new one from Jayhawk Bowling. When looking at wires noticed following..Plastic cover that protects and insulates wire saw bare wire as in time ate the cover away seeing bare wire probly grounding on Pinsetter frame confusing I.O. Board letting A full set from being set. It was on the 5 Row wire way.. So I am installing a new Wire harness assembly brand new and hopefully will cure problem.. Was going to jimmy it but problem will return.. Whats your thoghts on this move?

    Leave a comment:


  • Jesse Mech 69
    replied
    Also, try moving that pinholder to see if the issue follows the holder

    Leave a comment:


  • Eric Regalado
    replied
    Sounds like the table harness or table cable

    Leave a comment:


  • justaskme
    replied
    if you take the pin out of holder and then cycle the machine will the solenoid open for the 5 pin to release into the holder, if yes then but still doesnt open when setting then it could be a wire issue as i have come across where you will have continuity when machine is at zero but no continuity when at setting position

    Leave a comment:


  • walledup
    started a topic 5 Pin holder flaps

    5 Pin holder flaps

    Helping another center with there GS machines.. Lane 5 Does the following.. Goes to set pins on spot and brings back up the 5 Pin which creates table jam next full set of pins. Flap seems not to energize open on spot position releasing on spot five pin.. I switched cup holder assembly with newer working solonoid and switch.. Looked at block connectors male and female along with harness. Just need a jump start or wisdom of a ace to correct this problem...

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Help-broken Part

my crew was clearing a pin jam when the part fell on to the pin-deck. no enough experience to know where this is or what it's called. looking for help so we can order the part...
 

Qubica VDB Battery Replacement Part 2.

Greeting all.
I am sharing a link for a video, part 2, on how I replaced the battery in a Qubica VDB unit.
Thanks for looking.
Bolton454
 

Pin Damage

I have GSX pinsetters just over one year old. Just one of my machines is causing this damage to my pins. I have already adjusted the pin deflector boards to cover the bottom bolts...
 

Making TDM's adjustable.

I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
 

1:1 shaft wear

Hi all....I have a pinsetter that knocks over pins at times when setting new pins. The moving deck shifts very abruptly right around 270 degrees. Instead of a smooth movement,...
Working...
X