Announcement

Collapse
No announcement yet.

GS-98 Frameworx Lane Pair Hanging Up Second Ball

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GS-98 Frameworx Lane Pair Hanging Up Second Ball

    I've got a pair that is hanging up after the second ball on each lane. The tables are down in detect much like the console was frozen, but the hang-up is only temporary. Only happens after second ball, table stays in detect for ~10-15 seconds, then goes back up, and everything is fine until the next post-2nd ball cycle.

    I KNOW I've seen this exact same thing discussed on here before, but between having 30 second search intervals, a seemingly worse search than before, and some threads just outright corrupting during the software change, I can't find it.
    Fix it the right way? You can't do that unless it worked right to begin with.

  • #2
    Nevermind, found it.

    For reference: http://www.bowltech.com/forums/showt...14594-2nd-ball
    Fix it the right way? You can't do that unless it worked right to begin with.

    Comment

    Topic Starter RibbonScript

    Collapse

    Adsense Classic 2

    Collapse

    Related Topics

    Collapse

     

    A2 1 to 1 Gear Box Cover Replacement Due to Crack

    I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
     

    Streamlane Mask Halo Lights

    With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


    ...
     

    Hybrid (and EcoFriendly) Bumpers (2012)

    It's been about 10 years since we first tried this - 46 lanes and still working fine, auto air bumper cylinders on the BankShot bumpers. Here are videos of a home install with...
     

    Baddest Tool Chest In Town

    Adios, motor boater!

    ...
     

    Aluminum Repair and Welding

    with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
    http://aluminumrepair.com/...
     

    Setting Table Harness Connections

    Hi, guys.

    We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
    Working...
    X