Announcement

Collapse
No announcement yet.

J1 error dode

Collapse

Adsense Classic 1

Collapse

TOTY

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    J1 error dode

    Hey everyone,

    I have 6 GS-X machines and 10 GS-98s.

    I'm getting J1 error codes quite regularly on different lanes. It occurs on both the GS-X and the GS-98. Is there anything I can do to diminish the occurance of these? The cause 90% of the time is that the detector plates on pins 1-4-5-6 get caught on the wrong side of the little lip on the base of the spotting tongs and this makes it so the pin holders cannot go to their horizontal position. It seems to happen randomly and usualy doesn't have anything to do with pins getting stuck in the table etc...

    I've checked the detector plates and they seem fine.

    Ideas?
    Tags: None
  • #2
    Are the little lips on the spotting tongs worn down?

    Comment

    • #3
      No, they seem fine to me. It happened again last night a couple of times on two different lanes.

      Comment

      • #4
        Are the pivot pins that attached the pin detector plate to the pin holder worn?

        Comment

        • #5
          Nope. They are all fine. I replace them if they show too much wear.

          Comment

          Previous template Next

          Topic Starter RibbonScript

          Collapse

          Adsense Classic 2

          Collapse
          widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
           

          MP Chassis Tester

          Good morning,
          I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
          I am using relays. My question is to anyone that may...
           

          Preventative Maintenance - As, Jets, A2s - LEDs

          Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

          www.ledsupply.com...
           

          4:1 Timing off..

          *sigh* Hello friends..

          I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
           

          Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

          Left a rant about this in the bowling forum…

          I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
           

          Turret clutch rebuild

          At what thickness do you replace the clutch face.
          Is there a minimum dimension from the clutch face to the rivet.

          Thanks...
           

          Solderless relay conversion

          Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
          Working...
          X

          We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.

          By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.

          I Agree