Announcement

Collapse
No announcement yet.

about gsx machines

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • about gsx machines

    hey guys

    was wondering i have my back to all my lanes is there a way a could maybe set up something with red leds on a borad so a can see what lanes have fault

    do u think it posible to do

    any info would help

    cheers

    kind regards
    stephen

  • #2
    Yes. There is a remote upgrade, but I think it's only for GSX.
    Here is a link to the installation instructions:

    http://www.brunswickbowling.com/down...0_rev_8-10.pdf

    In Europe, get the info fromExchange Depot in Hungary by dialing 00-36-22-512-917 or by sending an e-mail to [email protected].

    You can also just have a remote light come on when there is a stop by extending the existing 2 wires to a board you can build and put about anywhere.
    Last edited by Ted; 02-12-2012, 04:28 PM.
    .
    .
    .
    This post is not an unpaid promotion of my business.

    Comment


    • #3
      If your back is to the machines and you're facing a computer, try VNC Viewer.

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse

      Related Topics

      Collapse

       

      A2 1 to 1 Gear Box Cover Replacement Due to Crack

      I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
       

      Streamlane Mask Halo Lights

      With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


      ...
       

      Baddest Tool Chest In Town

      Adios, motor boater!

      ...
       

      Aluminum Repair and Welding

      with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
      http://aluminumrepair.com/...
       

      Setting Table Harness Connections

      Hi, guys.

      We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
       

      check this jam...

      the ball stuck the table up

      ...
      Working...
      X