Announcement

Collapse
No announcement yet.

GSX keeps throwing J1

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • krull_777
    replied
    lol now that's funny

    Leave a comment:


  • StrikerzFacDir
    replied
    Did you tighten it back down afterwards???

    Leave a comment:


  • KennyMoyer
    replied
    I think I got it fixed. I loosened the TS1 switch, and adjusted the timing a little, and haven't had any problems as of yet. Thanks

    Leave a comment:


  • JulianD
    replied
    Are the back row pin detector plates catching on the setting table frame?

    Leave a comment:


  • MCSS
    replied
    Check the roller on the rear swing shaft to see if it is catching on the latch. I've had this happen on a few machines in the last few months due to parts breaking in and loosening up.

    Leave a comment:


  • Pinchezr
    replied
    Are all the pins being loaded? Could be there is one pinholder that has a broken switch, and is "waiting" to receive a pin.

    Leave a comment:


  • KennyMoyer
    started a topic GSX keeps throwing J1

    GSX keeps throwing J1

    Lane 18 at our center keeps throwing J1. when the table is coming up to the home position to load pins, the latch on the square shaft that goes with the stroke limitor is not being pulled back to clear the swing shaft. Replaced latch and shock and solenoid on stroke limitor, but all were good. Any ideas?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse
widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
 

Rake sweeping out of time, and pin launching onto lane.

I work on some nice old Brunswick A-2 pin setters. Most issues I've come across haven't been to problematic to figure out. But being I can't seem to get it to recreate the issue...
 

Strange sweep problem

I’m a rookie mechanic and have been working on pinsetters for 2 years. One of my lanes has a problem with a sweep possibly coasting. I don’t know what could be causing it...
 

GSX Distributor shaft bearings

Two part topic:
1. Plastic bearing (#66) used in place of regular sealed bearing (#51) -- thoughts?

2. ANY of these bearings with the black support mount...
 

The Legacy of the A2

I was recently disheartened to learn that a bowling center that I once serviced was actively looking to replace their A2's. I understand that most military bases and educational...
 

Table turning on short stroke.

Hello dear Bowltech members.
First let me say thank you for your time. am plagued by a big issue for three weeks now.
our technician is working full time on another...
 

Another pivot bearing broke.

One and a half year old GSX machines. This will be the 5th pivot bearing that has broke. This one decided to take out a few things with it. Snapped the stroke limiter shock stud...
Working...
X