Announcement

Collapse
No announcement yet.

GSX No power

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GSX No power

    Rain storm, roof leaked onto pinsetters, one pair down no power. When I got here today, they were dry so I dont really know what got wet. Power is good going into the box, power going to the contactor but no low voltage to pull the contactor in. No power to display or CPU. I've changed the power board and swapped transformers with no change. Can someone direct me through this?? I would love to just order another nexgen box but big B doesnt exchange them complete.


    thanks

  • #2
    The bottom most fuse in the center of the CPU board is probably blown. Seems the CPU board isn't ptotected from surges like it should be. that fuse powers the CPU. You'll probably have to replace the board.
    .
    .
    .
    This post is not an unpaid promotion of my business.

    Comment


    • #3
      Thanks Ted. I found the problem, it was my fault. When I was working on replacing the board, I leaned up against the emergency stop, tripping it. I knew I did it when it happened but my hands were too tied up into getting that board in and by power up time I had totally forgotten about it. Was just in too much of a hurry to get it up and running. I guess I'm getting old and senile... LOL...

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse

      Related Topics

      Collapse

       

      A2 1 to 1 Gear Box Cover Replacement Due to Crack

      I am refurbishing two converted A2 machines that I will be installing in my home basement this fall. One of them has a leaking gear box and cracked 1:1 gear box cover. I have...
       

      Streamlane Mask Halo Lights

      With huge thanks to "Toby" for all his help & expertise...my old masks now have for-real halo lights again.


      ...
       

      Baddest Tool Chest In Town

      Adios, motor boater!

      ...
       

      Aluminum Repair and Welding

      with our broken moving deck i have been asked to figure out if there is a way we can weld it back together in house for very little expense.
      http://aluminumrepair.com/...
       

      Setting Table Harness Connections

      Hi, guys.

      We recently replaced our setting table harness and when the machine's run in diagnostic mode, we get 01, 02, 03, 04 + 09 errors, or when you place pins...
       

      check this jam...

      the ball stuck the table up

      ...
      Working...
      X