solenoid shark switch not working

[bowlthai]

I think the card I / O PCB waste.
I would like repair. Please advise how to fix it for me.

Thank you.

[sbrooks]

more information please

[mardigras]

Have you moved I/O board to another pair and see if it followed?

[bowlthai]

I moved to the new board. To operate normally. I would like repair board. But I do not know how to change the IC.

[Bearded_Stu]

Do you definitely know its the board that's gone? I had it once where the bit of plastic holding the shark in place was broken off, so it just wouldn't move at all

[J_Rakow]

I would recommend you have good soldering skills.

The triacs for the Consolidated Electronics I/O are

Q2:Pin 1 solenoid
Q3:Pin 2 solenoid
Q4:Pin 3 solenoid
Q14:Spotting tong solenoid
All of them are protected by CB2.

Q5:Pin 4 solenoid
Q6:Pin 5 solenoid
Q7:Pin 6 solenoid
Q15:Sweep release solenoid
All protected by CB3

Q8:Pin 7 solenoid
Q9:Pin 8 solenoid
Q10:Pin 9 solenoid
Q16:Stroke limiter solenoid
All of them are protected by CB4

Q11:Pin 10 solenoid
Q12:Ball door solenoid
Q17:Shark solenoid
All of them are protected by CB5

Those transistors are TIP120's which are available at Radio Shack. Be very careful. It's easy to booger up the board trying to unsolder those and get them off. Make sure you use caution and precision instruments.

[bowlthai]

Thanks for the suggestion. I've changed Q17: Shark. solenoid is not working.