No announcement yet.

table Height measuring block part #?


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • table Height measuring block part #?

    I know I've seen it before in the documentation somewhere but now when I am trying to find it to order it I can't find it. If you don't know what I'm talking about I'll explain

    There is a block that brunswick sells that makes getting proper measurements for table height super simple it looks like a tiny staircase and it's a total of 137mm long for the highest measurement. Does anyone have the part number for this so I can order one and make my life easier. Thanks in advance.

  • #2
    Gauge Block 47-900012-000


    • #3
      Yes! thank you. Where did you find it?


      • #4
        Genuine Brunswick Parts catalog.... there's a GS Tools|Maintenance page. Most recent catalog is Here


        • #5
          Thanks I knew I had seen it somewhere but I couldn't remember where.


          Topic Starter RibbonScript


          Adsense Classic 2

          widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

          MP Chassis Tester

          Good morning,
          I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
          I am using relays. My question is to anyone that may...

          Preventative Maintenance - As, Jets, A2s - LEDs

          Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.


          4:1 Timing off..

          *sigh* Hello friends..

          I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

          Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

          Left a rant about this in the bowling forum…

          I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

          Turret clutch rebuild

          At what thickness do you replace the clutch face.
          Is there a minimum dimension from the clutch face to the rivet.


          Solderless relay conversion

          Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...