Announcement

Collapse
No announcement yet.

Ball rail spacer

Collapse

Adsense Classic 1

Collapse

TOTY

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ball rail spacer

    This month I was changing plastic covers on my GSX accelerator ball rails. I lost one of the spacers under the rail. (GSX Parts Book, PG 9D, item 27. #47-035214-004.) These spacers are no longer available. After a bit of investigating by my TOP DOG supplier, he found the number has been changed to 47-860014-000. It was a bit of a pain to find this # so please amend your book for future refrence.
    In a pinch, I guess I could have used a few lock washers stacked up, but I prefer to do it right, no shortcuts.
    John

  • #2
    Good to know.

    Comment


    • #3
      Ive found that Brunswick like to change part no's and dont tell you!!

      Comment

      Topic Starter RibbonScript

      Collapse

      Adsense Classic 2

      Collapse
      widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
       

      MP Chassis Tester

      Good morning,
      I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
      I am using relays. My question is to anyone that may...
       

      Preventative Maintenance - As, Jets, A2s - LEDs

      Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

      www.ledsupply.com...
       

      4:1 Timing off..

      *sigh* Hello friends..

      I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....
       

      Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

      Left a rant about this in the bowling forum…

      I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....
       

      Turret clutch rebuild

      At what thickness do you replace the clutch face.
      Is there a minimum dimension from the clutch face to the rivet.

      Thanks...
       

      Solderless relay conversion

      Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...
      Working...
      X