No announcement yet.

resetting spares


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • resetting spares

    I'm new to the GSX's. Always been an 82-70 and A2 tech.

    Curious, how do you reset a spare that has been swept or fallen over?

    Thanks in advance

  • #2
    They are done from the front desk, atleast with Vector software. It's under "lane Status", highlight the lane that needs the pins reset then at the bottom right hand part of the screen go to pinsetter control. From there you can set any combination of pins.
    Mechanical Opperations Supervisor
    Mac Daddy's LLC


    • #3
      Adding to the above, in some cases, simply pushing the "set" button will reset the last known detection from pin holders. This may help in some cases.


      • #4
        If the machine scored correctly the set button will work, if not pin fork like on the 70's.
        For Sale, Parachute. Only used once, never opened, small stain.


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...