Announcement

Collapse
No announcement yet.

Pin not dropping into the pin holder

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ted
    replied
    We know the connections and wire break points can change as the table moves and tilts to vertical. Some of these intermittent issues are hard to pinpoint. Squeeze the female molex sockets inside the connector at the pin holder as a first try remedy. I always tug on each wire with needle nose- on both sides of the connection - to see if the wire within the jacket is intact.
    Last edited by Ted; 07-17-2013, 03:34 PM. Reason: 'Exactly what sbrooks says'

    Leave a comment:


  • sbrooks
    replied
    Nexgen to table cable. bad connector on pin holder (female molex may be loose)

    Leave a comment:


  • JulianD
    replied
    Bad setting table cable, or nexgen to setting table cable.. Check the resistance

    Leave a comment:


  • Flessan
    replied
    May be a bad contact or wire between the pin spotter and the smart cable.

    Leave a comment:


  • Forumbowling
    started a topic Pin not dropping into the pin holder

    Pin not dropping into the pin holder

    Hello everyone,

    I've been having an intermittent problem with one lane for a while now and its been getting more regular and more annoying.

    I'm getting error code 02. The pin is not dropping from the pin station into the pin holder. Upon closer observation I noticed that this is being caused because sometimes the pin holder arms do not open or open too late (they open after the table is already in the up position, therefore they do not activate the pin release lever).

    I've replaced the entire pin holder and the problem has persisted.

    Any ideas?

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse

Related Topics

Collapse

 

Help-broken Part

my crew was clearing a pin jam when the part fell on to the pin-deck. no enough experience to know where this is or what it's called. looking for help so we can order the part...
 

Qubica VDB Battery Replacement Part 2.

Greeting all.
I am sharing a link for a video, part 2, on how I replaced the battery in a Qubica VDB unit.
Thanks for looking.
Bolton454
 

Pin Damage

I have GSX pinsetters just over one year old. Just one of my machines is causing this damage to my pins. I have already adjusted the pin deflector boards to cover the bottom bolts...
 

Making TDM's adjustable.

I have some machines that the time delay cycles like right now when machine is triggered instead of the 3 sec delay. Would like to put in a potentiameter to correct this. Does...
 

Gold Crown Masking Unit

Here are some photos of a Brunswick Gold Crown single masking unit that I refurbished. I stripped off the old orange vinyl skin and used it to make a template for the new green...
Working...
X