No announcement yet.

Gotta love it...


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Gotta love it...

    Picture says it all!

  • #2
    The ball looks like an EPCO Starline. Bet that ball got chewed up nasty from that little incident.
    "Oil patterns?!? We don't need no stinkin' oil patterns!"


    • #3
      Yup, it was a starline, and yes, It sure did! Haha Bowler threw a gutter and it flew up. Must have either bounced off the back wall and into the pinlift or landed directly in.


      • #4
        Starlines are so soft, they get banged up by anything.
        "Oil patterns?!? We don't need no stinkin' oil patterns!"


        • #5
          those little bastards always find their way to somewhere they don't belong. hated those stops.


          Topic Starter RibbonScript


          Adsense Classic 2

          widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

          MP Chassis Tester

          Good morning,
          I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
          I am using relays. My question is to anyone that may...

          Preventative Maintenance - As, Jets, A2s - LEDs

          Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.


          4:1 Timing off..

          *sigh* Hello friends..

          I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

          Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

          Left a rant about this in the bowling forum…

          I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

          Turret clutch rebuild

          At what thickness do you replace the clutch face.
          Is there a minimum dimension from the clutch face to the rivet.


          Solderless relay conversion

          Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...