No announcement yet.

blower motor C90 return


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • blower motor C90 return

    I'm searching out a good part number for the blower motor for our Concept 90 Ball Returns. What I have is 250-001-412 but I remember ordering one in the past and received a blower with 2 vents side by side. what we have is a single vent blower. Thanks for any help.

  • #2
    if they run on 110v you can get it at schemm bowling for about $88.00 part number SB8660 quality also has one that will run on both 115 and 230. this is what i run in my c90's. the catalogs say they are for b2000's and frameworks lifts, however its the same motor for the c90's.


    Topic Starter RibbonScript


    Adsense Classic 2

    widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

    MP Chassis Tester

    Good morning,
    I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
    I am using relays. My question is to anyone that may...

    Preventative Maintenance - As, Jets, A2s - LEDs

    Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

    4:1 Timing off..

    *sigh* Hello friends..

    I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

    Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

    Left a rant about this in the bowling forum…

    I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

    Turret clutch rebuild

    At what thickness do you replace the clutch face.
    Is there a minimum dimension from the clutch face to the rivet.


    Solderless relay conversion

    Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...