If you are seeing this you are not logged in to Bowl-Tech. Remove this notice by Registering or Logging in
By your continued use of this site you agree to the following.
You are over the age of 18 and have had supervised training in safety and operations of the equipment you work on.
Bowl-Tech does not warrant or guarantee the accuracy of information found on this site. Bowl-Tech, its officers, site Admins or Moderators will not be responsible in the case of losses financial or otherwise as a result of use of ANY information on this site.
Bowl-Tech is not a substitute for proper training on bowling equipment maintenance. You will seek personal training from trained professionals within your center with regards to safety & maintenance practices while working on bowling equipment.
Posts on the site are made by registered members and each member is responsible for the content and accuracy of their posts.
If you can not agree to any of these terms of use above or are not at least 18 years of age you are asked NOT to visit Bowl-Tech or utilize its content. To visit the Bowl-Tech Terms of Service and Rules CLICK HERE
Please join our community. It is easy and gives you additional access to forums and other tools. CLICK HERE to join
Hey guys,
was doing normal nightly maintenance one night this week and noticed it seems like more and more pitboards are starting to hold pins at both sides (in the gap between kickbacks and pitboard). The boards are centered pretty well, and I just got done replacing all our blown pit rubber-mounts.
Is anyone else having similar problems? It's a small worry, but there are definately more now than ever has been.
Matty:
Pretty common problem, unfortunatly once it starts, will continue to get worse as edges of carpet wear, certainly aggravated with use of carpet covers. On boomer fastened pit frames I find it helpful to bolt a 1 inch long peice of 3/4 angle iron to very outsides of frame at point where boomer clamp is located, thus positivly keeping board centered
Roscoe
Ok, I just had one of my company's centers in Florida reach out for help with this issue, and I wasn't able to help them over our chat, so I'm hoping you guys can help shed some...
What causes the trip rocker arm to not line up with the trip rod? Carriage tubing is not bent and all eccentrics are brand new.
I understand I can bend the rocker arm a...
Just wondering if this is the normal way that these boards go over time? Am i missing something?
Pit curtains are in "reasonable" condition if that means anything...
Hi guys, got a few of these Lewus solid state start switches and wondering if we could make use of them on our combi motors. I've seen they aren't recommended for combi motors...
I have a machine that has broken the cam follower arm for the deck lowering hook on the 2 to 1 twice in a couple weeks. I've overnighted the part so i can change it tomorrow....
Working...
X
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Tweet
Comment