Announcement

Collapse
No announcement yet.

rake rubber strip

Collapse

Adsense Classic 1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Guest's Avatar
    Guest replied
    Re: rake rubber strip

    Yep. That's the way to do it.
    Weldwood is the cat's meow.

    Leave a comment:


  • Steve Stafford (JBEES)
    replied
    Re: rake rubber strip

    Weldwood contact cement. Put cement on both mating surfaces and allow it to dry on both surfaces. Don't goop it on, just a thin layer. Drying time should be between 5 and 15 minutes. Once applied to each other, they will stick immediatley. You will not need to wire tye them on because the glue will already be dry. I leave the upper part that loops over the top of the rake board dry...it will stay on if the lower flat part is glued on to the back of the rake board. Hope this helps you...

    Leave a comment:


  • Howard
    started a topic rake rubber strip

    rake rubber strip

    I noticed that some of the rakes were rather noisey when sweeping all 10 pins off. The rubber strips are missing! I found several in the back room hanging up on the wall. What would you suggest on reattaching them to the rake boards? Rubber cement? I thought I would glue them back on and then use black nylon wire ties to hold them tight until the glue dries. Any suggestions would be appreciated. Thanks.

Topic Starter RibbonScript

Collapse

Adsense Classic 2

Collapse
widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.
 

Well this is a first.

We all from time to time have one of those “wow I’ve never seen THAT before” moments. Well today was one of those for me when my night tech texts me to say lane 16 is out...
 

Ball return wheel guide roller removal.

Hey guys, i could just use a bit of advice trying to get this part out, first time I've had to do one of these. I got it to move a few turns but its come to a point where it has...
 

Even old mechanics find something new.

All my years working on these things I never had this happen…… until last week. ...
 

82-90XL Frontend Gearbox Parts - Rebuild Woes

We have 5 of the 088000365 replacement gear kits on the shelf, and I pulled two gearboxes off machines earlier this week, so I thought I'd try my hand at rebuilding them and save...
 

Prolane damage

Can this be repaired?
 

LED Ball Lights

Made an LED conversion for A2's and Frameworx masks. It can also be modded for the Harmony masks to accept 2 x 5mm led's and/or a 12v supply. Once I'm happy with the performance/design...
Working...
X