No announcement yet.

Pin wheel belt clip fastener


Adsense Classic 1



  • Filter
  • Time
  • Show
Clear All
new posts

  • Pin wheel belt clip fastener

    I couldn't find the thread of people looking for these so i started a new one.

    So we were looking for the fasteners for our pin wheel belts and was directed to a large bowling supply center that wanted $20.50 each for them.

    Here is the manufacture:

    You will need to purchase through your local dealer. Such as Motion Ind, Grainger, Applied Industrial...
    Note I am not advertising for anyone or naming the overpriced bowling supply house.
    These fasteners sell for less than $4ea at the date of this post.

    The "metal fastener" for "open ended belting" comes in 2 sizes. Size A for 3/8' belt and B for 1/2" belt.

  • #2
    the link only has the belts not the joiners
    Duct Tape or a Sledge Hammer......such a hard choice


    • #3
      I have the number at work, will post it tuesday afternoon.
      Gene Simmons for president!!!


      • #4
        The "metal fastener" for "open ended belting" comes in 2 sizes. Size A for 3/8' belt and B for 1/2" belt.

        Size A or B is part number for "open ended belting" from Jason Industrial.

        I linked that page for reference to the belt I am discussing.

        Sorry for confusion


        Topic Starter RibbonScript


        Adsense Classic 2

        widgetinstance 666 (Related Topics) skipped due to lack of content & hide_module_if_empty option.

        MP Chassis Tester

        Good morning,
        I have built a tester for the MP Chassis for the 82-70 machines. Instead of using the cam switches
        I am using relays. My question is to anyone that may...

        Preventative Maintenance - As, Jets, A2s - LEDs

        Those of you looking for new LED lighting ideas may want to check out this site. Lots of stuff.

        4:1 Timing off..

        *sigh* Hello friends..

        I had a 4:1 go bad and I've never seen or done one before. Trying to search the depths of the forums, YouTube videos, it didn't seem too bad....

        Adapting the Bluffton end cap & terminal board kit to Franklin BE (and FE) motors.

        Left a rant about this in the bowling forum…

        I’ve already repaired a a number of Franklin FE motors using the Bluffton-style end cap and terminal board kit (090-004-582)....

        Turret clutch rebuild

        At what thickness do you replace the clutch face.
        Is there a minimum dimension from the clutch face to the rivet.


        Solderless relay conversion

        Is anyone running the solderless relays on the accelerators? How do you like them? What brand? How difficult to convert was it? Would love the feed back as I'm about to switch...